Yodify DEC Brand Library
WKv Series Low Energy Heat of Compression Compressed Air Dryers (Full Stream)
WKv Series Low Energy Heat of Compression Compressed Air Dryers (Full Stream)
Brand: ZanderParker Zander WKv series compressed air dryers are fully automatic dryers which utilize full flow regeneration principles to dry compressed air down to a pressure dew point of -20 °C.
WKv series dryers are so called heat of compression dryers (HOC), in contrast to conventional adsorption dryers, HOC dryers make use of excess heat from oil-free compressors to regenerate the desiccant beds thereby eliminating the requirement for an installed heater.
HOC dryers are therefore a cost and energy efficient solution.
WKv series come with a ZDMC controller as standard that offers full process visualization and advanced connectivity.
WKv series compressed air dryers are available for volume flows up to 14500 m³/h with a standard maximum operating pressure up to 10 barg.
Higher flow rates, operating pressures or temperature ratings are available on request.
Features- Volume flows up to 14500 m³/h @ 7 bar g
- Maximum operating pressure 10 bar g - higher pressures on request
- Pressure dew point: -10 to -50°C - lower dew points available on request
- Operation with up to 3 compressors
- Operation with low flows (30%)
- Very low operating costs by using the compressor heat - only cost is power for the control unit
- Very quiet operation - no purge / expansion, no blower or vacuum pump
- Low service costs - no heater, no blower, no load changes
Many additional options are available to suit specific customer requirements.
Specifications
Brand
Maximum Flow Rate (at 101 psig / PDP - 4° F)
- 247 to 8534 CFM
Maximum Operating Temperature
- 104° F
- 40° C
IP Protection Rating
- IP54
Minimum Ambient Temperature
- 1.5° C (Insulation Required if Temperature is Below 15° C)
Electrical Requirements
- 230 V, 50/60 Hz
Power Consumption
- depends on Design
Maximum Ambient Temperature
- 50° C
Minimum Operating Pressure
- 2.5 barg
Maximum Operating Pressure
- 145 psig
- 10 barg
Minimum Operating Temperature
- 68° F
- 20° C
Width
- 1250 to 3750 mm
Connection Type
- Flange According to EN 1092-1
Controller Type
- ZDMC2
Depth
- 950 to 2500 mm
Height
- 2355 to 4440 mm
Approvals & Certifications
- Others on Request
- PED
Water Consumption
- 3.50 m³/hour to 121.30 m³/hour
Dryer Technology
- Fully Automatic Adsorption Dryer with Heat of Compressor Usage for Full Flow Regeneration
Pressure Dew Point
- 14 to -58° F
- -10 to -50° C
Port Size
- DN 40 to DN 200
Weight
- 616 to 16350 kg
Brand-Managed Distributed Enterprise Catalogs (DEC)
for Authorized Channel Partners
for Authorized Channel Partners
Book a DEC Demo